Infrastructure required for the Ferial water treadmill

Ferial water treadmills consist of several parts, the spaces and infrastructure facilities required for each of which are explained below.

– Treadmill Box: Ferial’s human blue treadmill boxes are currently manufactured in two models.

The X2000 model is produced with a width of 85 cm, a length of 170 cm, and a height of 170 cm.

The SX2000 model is produced with a width of 95 cm, a length of 210 cm, and a height of 200 cm.

In the SX series, for ease of transportation, the treadmill is made in several pieces, and to transport it, it requires a width less than the completed model, equivalent to 85 centimeters, and 170 centimeters in length.

In both models introduced, at least a 50 cm margin is required around it; the next thing is to have a shoebox where the box is located, which is better if there is one, but there is no requirement for this.

– Water storage tank: Water tanks come in various shapes and sizes, which can be chosen depending on the installation location; however, access to a cold water line is essential to fill the tank; a drain or sewage outlet is also required for times when the tank water needs to be replaced.

– Water treadmill installations: Each water treadmill has four pumps that are used to fill and drain water, as well as a heating and filtration system; this equipment can be installed in different spaces and placed according to the existing environment.

Ozone generator: An ozone generator is used for chemical water purification. It should be installed at the highest point in terms of height, and ventilation is also preferably required at its installation location.

Heating system: Heating of Ferial water treadmills can be implemented in three ways; the first method is to use a gas water heater, which requires a city gas flame and a suitable chimney.

The next method is for places that either use a package for the heating system or have a motor home, in which case a special exchanger is used to heat the treadmill water.

And the last method is to use an electric water heater, which is not cost-effective due to the high cost of electricity compared to gas; however, if needed, this method can also be applied to places that do not have city gas.

Electrical panel: The electrical panel required for water treadmills is sent by the company with the device, which only requires a 25-amp single-phase electrical input.